The 5 gentle neck stretches you NEED to reduce pain. When I bought the new bulb at autozone, the person there offered me a packet of 'something' which was supposed to keep moisture that tend to collect at the light from corroding the connections. One of the two brake lights on my driver side is out. What do I do if my stop headlights are stuck on? Be careful not to lose the mounting hardware. If the brake lights are stuck in the on or off position, the switch may be the problem. We've been helping billions of people around the world continue to learn, adapt, grow, and thrive for over a decade. I went to go manually remove the brake light from inside the trunk, and could not get the top socket/bulb out. Get it as soon as Tue, Jan 5. Bad Socket. Ericsan on September 22, 2012. Cut the potato in half and press it firmly against the socket. Use needle nose plier, insert push in then spread as to apply pressure to unlock bulb. It seems to be stuck. The bulb is an old fashion type. wikiHow is where trusted research and expert knowledge come together. If that is the case, you will need to check each of them. If my brake light is on will my car pass the smog test? FREE Shipping on orders over $25 shipped by Amazon. Brake lights are intended to keep other drivers aware of you reducing your speed, so faulty brake lights could result in accidents. Powered by Discourse, best viewed with JavaScript enabled. These systems may not work if the brake light switch has failed. % of people told us that this article helped them. Yes, you’ve heard this right: you can use a potato to remove a broken bulb from its socket. wikiHow's. This is a fire hazard and causes an additional safety hazard with the loss of the brake light. 1-24 of 145 Results. wikiHow's Content Management Team carefully monitors the work from our editorial staff to ensure that each article is backed by trusted research and meets our high quality standards. 3rd Brake Light Bulb Socket (W0133-1638504-OES) by Genuine®. You may be able to adjust the positioning of the brake light switch. Your brake lights are an essential part of your braking system. Brake filament works but running light filament is out. This article has been viewed 461,346 times. What is missing? I put a new brake light switch in, but the brake lights are still staying on. Break off any remaining glass, being very careful while doing so. 99. Unless the pigtail harness needs to be replaced, you will reuse it with the new brake light switch. What do I do if my brake lights are stuck on and I have enough brake fluid? Duralast Brake Lamp Socket 703 $ 19. If the lights turn off, then the switch is working and you just need to replace the stop. Pull the old bulb straight out of the socket and replace it with the new bulb. Or if the housing is melted, then you can replace whatever is required. At issue is the brake pedal stopper pad -- this part can wear down over time and allow the brake light switch to remain on after the driver takes his or her foot off the brake pedal. Checking the Brake Light Switch for Damage, {"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/e\/e9\/Fix-a-Stuck-Brake-Light-Step-1-Version-2.jpg\/v4-460px-Fix-a-Stuck-Brake-Light-Step-1-Version-2.jpg","bigUrl":"\/images\/thumb\/e\/e9\/Fix-a-Stuck-Brake-Light-Step-1-Version-2.jpg\/aid1386843-v4-728px-Fix-a-Stuck-Brake-Light-Step-1-Version-2.jpg","smallWidth":460,"smallHeight":345,"bigWidth":728,"bigHeight":546,"licensing":"